Puncher

1. Consumables

As supplies in the drill presses are used chisels, spades, augers, drills and other cartridge punch is designed for those "cap", which are used for modes of perforation and chiselling (drills, chisels, spades). Drills also attached to the shaft of the punch through the removable cartridge.

• Diameter of drill or auger are selected depending on the type of surface and the diameter of the holes you want to drill. There are special drill bits for wood, bricks, tiles, etc. Drill diameter should correspond to the diameter of the hole.
  

2. Drilling

Patron punch replace a keyless chuck. Then set the drill bit, corresponding to the type of material, which is planned to drill. In this case, a drill on a tree. Tools transferred to the mode rotation. This mode, which employs the usual drill. You can adjust the number of revolutions in the work - the more pressing the trigger, the faster the speed of rotation. Also, the number of pre-defined electronic speed limiter, located directly on the trigger.

• Mode of rotation is used for making holes of any depth and diameter in different types of surfaces;
• Begin the work should be at a low speed, gradually increasing speed. To begin drilling immediately at the maximum speed is not recommended, since the end of the drill may be off the markings;
• Compared with the regime of drilling and chiselling, which can greatly push the tool in drilling mode, you can make a little effort, but within reasonable limits (load up to 5 kg).
  

3. Shtroblenie

Old ceramic tile dismantled by shtrobleniya. In the tool holder is clamped chisel. Then manually regulate the angle of direction chisels - so that was convenient to work with the surface. Setting a chisel under the necessary angle, his position is rigidly fixed by a special lever, located on the body punch. Tools transferred to chiselling mode without rotation (mode pneumatic drill). End chisel is inserted into the seam tiles. Gradually increasing the impact velocity, tile Stroebe direction from the edges toward the middle.

• Surface is usually Stroebe in order to make the grooves for the wiring, wiring for communication or to dismantle the old ceramic tile (as in our case). Use peak or a chisel;
• Mode shtrobleniya pre-impact velocity is not exposed, but varies during operation. The number of strokes depends on the trigger pull (the more you squash, the greater the number of beats).

4. The destruction of the surface

To make a rut in the concrete surface, also use chiselling mode without rotation. Pick from a wide spatula is fixed in the tool holder and is fixed under the necessary angle.

• Attack speed in the chiselling mode is recommended to regulate the work process (by pressing the trigger), speed display options in advance is not required.
  

5. Drilling (punching)

In punch perpetuate the drill chuck. Tools transferred to the rotation mode of attack, begin to work. The higher the power punch, the better its performance, ie The holes faster. Starting work at low speed, gradually adjusted to the maximum number of revolutions.

• When working punch in the mode of drilling, before inserting a drill in the chuck, shank it must necessarily blur!

6. Tightening the screws

Trehrezhimny punch can be used as a screwdriver. The usual substitute for chuck keyless. Screw chuck and transfer tool in the regime of rotation without impact. We should expose the direction of rotation with the reverse. Exhibited the lowest possible speed. Establish: drill perpendicular to the surface and it is screwed into the screw at low engine speeds. If the reverse transfer tool in the opposite direction, you can unscrew the screw.

• Pressure on the punch when used as a screwdriver should not be strong. Suffice efforts 3 - 4 kg;
• For screwing / wrenched screws, of course, easier to use separate tools - screwdriver, because it is easier to punch and smaller in size. However, for screwing a small number of screws (5 - 6 pieces) is justified to use punch.